Table of Contents
Advertisement
Post Effects
PAGE 1/3 - DELAY ROUTING AND RANGE
The menu on this page allows you to position (or route) your delay on either
the left or right channel. If you use the PedalPro Ex in a mono configuration,
select 'left' to insert the Delay in your effect chain (see
on page 41).
D l e a
Routing
Range: 23 0 9ms
Routing – Routing selector. Range: none, left, right
To change the routing, press EDIT [5]. Use the arrow keys [3] to position
•
the blinking cursor next to Routing. Adjust the value with the selection
dial [4]. When 'none' is selected, the Delay effect is deactivated.
Range – Available delay range. Range: 23-99 ms (short), 40-409 ms (medium),
61-614 ms (long)
To set the available delay range, press EDIT [5]. Use the arrow keys [3]
•
to position the blinking cursor next to Range. Adjust the value with the
selection dial [4].
TIPS & TRICKS - DELAY
•
For short delays (doubling echo, slapback, reverberation emulator) set
the Range parameter to 'short'; this gives you access to an analogue
delay with an adjustable range of 23-99 ms.
For medium delays (slapback and infinite loops) set the Range to 'me-
•
dium'; you can select your analogue delay from a range of 40-409ms.
•
For long delays (infinite loops, small phrase loops) set Range to 'long';
this produces an analogue delay with a range between 61-614 ms.
•
Finally, adjust the amount of delay applied, within the range that you
have just selected, on page
rameter Tempo).
Fig. 9-2
y
È
1/3
: e t
l f
- 9
2/3
of the Delay configuration menu (pa-
PAGE 2/3 - DELAY CONFIGURATION
This is the configuration page for the parameters of the Delay.
and
Fig.
9-3,
Time – Amount of delay applied. Range: 23-99 ms (short), 40-409 ms (me-
dium), 61-614 ms (long)
To change the amount of delay, press EDIT [5]. Use the arrow keys [3] to
•
position the blinking cursor next to Time. Adjust the value with the selec-
tion dial [4].
Inp – Input signal level selector. Range: 0-100%
The Inp (input) parameter controls the level of the signal at the input of the
Delay effect.
To adjust the input signal level, press EDIT [5]. Use the arrow keys [3] to
•
position the blinking cursor next to Inp. Adjust the value with the selection
dial [4].
Wet – Wet/dry ratio control. Range: 0-100%
The Wet parameter allows you to control the ratio between delayed signal
(wet) and input signal (dry) in the Delay output signal.
To alter the wet/dry ratio of the Delay, press EDIT [5]. Use the arrow keys
•
[3] to position the blinking cursor next to Wet. Adjust the value with the
selection dial [4]..
Out – Delay output level. Range: 0-100%
The Out parameter controls the output level of the analogue Delay effect..
To adjust the output level of the Delay, press EDIT [5]. Use the arrow keys
•
[3] to position the blinking cursor next to Out. Adjust the value with the
selection dial [4].
46
D l e ay
Time: 40 . 0 7
ms
I np: 050.
5
O
ut: 5 7
0 .
Wet: 045.
0
F
bk: 0 1
0 .
È
2/3
2
1
Advertisement
Table of Contents
