Barco Nio Fusion 4MP Getting Started Manual page 38

General tips
virtual display representing the two heads controlled by each
MXRT-2100 display controller.
If you installed your Nio Fusion 4MP drivers in DualView mode
(default for Windows XP) there will be a rectangle representing
each head controlled by each MXRT-2100 display controller. This
will be true even if you have only one display connected to your
MXRT-2100 controller. Both displays of a display controller cannot
be enabled at the same time unless their display properties
match. If necessary detach the second display of the MXRT-2100
display controller you are working with by right clicking on the
rectangle that represents it, deselect Attached and click the
Apply button.
Note: Since Windows will not let you detach the primary display
connected to a particular controller, you may need to temporarily
make another display the primary display
For the display which is still attached click Click on the Advanced
4.
Button.
Select the Adapter tab and then click on the List All Modes
5.
button. Select the resolution and refresh rate that your Nio Fusion
4MP display supports from the dialog box and click OK.
In the Adapter box, the Adapter string shows if this
Note:
display is the First View or the Second View attached to the display
controller. Please make a note of this, so that you can arrange the
displays in the correct order later if necessary.
Click OK on the bottom of the Adapter Control Panel. If the "OK"
6.
button on the bottom of the Adapter Control Panel is not visible,
press the TAB key once and then press CTRL+Enter to select OK.
Click OK in the "Windows will now apply your new desktop
7.
settings" dialog box. Your Nio Fusion 4MP display should now
synchronize and display the Windows desktop.
Click Yes when asked, "Your desktop has been reconfigured. Do
8.
you want to keep these settings?"
38