Barco Nio Fusion 4MP Getting Started Manual page 37

danger that colors will change when focus moves among different
applications.
However, if you are using the Color to Gray Compatibility palette mode,
the color setting for your high-resolution grayscale displays should
default to True Color (32 bits per pixel). Even though this palette mode
supports 32 bit True Color, Barco recommends that when using a using a
color display in conjunction with your high-resolution grayscale
display(s) that you still set the color display as the primary monitor of
the Windows desktop.
Setting the resolution of your N
Note: In order to set the resolution of your N
must be logged in using an account with administrator privileges.
Open the "Windows Display Control Panel" by one of the two
1.
methods below:
Start > Settings > Control Panel > Display
a)
or
Open the "Display Properties Control Panel" by right
b)
clicking in an empty area on the desktop, then select
Properties.
Click on the Settings tab.
2.
Select the rectangle that represents the Barco Coronis display
3.
whose settings you wish to change.
Note: If you are using the VGA capabilities of your MXRT-2100
display controller, the resolution for the first display may be set to
a VGA resolution of "640 x 480" pixels with 16 colors and a default
refresh rate. If your MXRT-2100 controller is not running VGA, the
display may not be enabled yet. To enable the display, check the
"Extend my Windows desktop onto this monitor" checkbox, but
do NOT click the Apply button at this time.
If you installed your Nio Fusion 4MP drivers in SingleView mode
(default for Windows 2000) there will be one rectangle for the
F 4MP
IO USION
F
IO USION
General tips
4MP you
37