Barco Nio Fusion 4MP Getting Started Manual page 20

Display parts, controls and connectors
Do not remove the seal.
USB upstream connector (to PC).
2.
USB downstream connector.
3.
If the display's USB upstream connector is connected to the PC USB
bus, you can use the USB downstream connector to connect
peripheral USB devices.
USB 2.0 devices are supported.
+5 Vdc, 0.25 A power output for accessories.
4.
+3.3 Vdc, 0.25 A auxiliary power output.
5.
"Left" DVI (digital) video input. See note below.
6.
"Right" DVI (digital) video input. See note below.
7.
USB downstream connectors
8.
If the display's USB upstream connector at the rear is connected to
the PC USB bus, you can use these USB downstream connectors to
connect peripheral USB devices.
USB 2.0 devices are supported.
Note: The MDNC-4130 disposes of 2 video inputs. You can
connect both video inputs or just one input.
• When both inputs are used (DuoView), the signal on the "left"
DVI connector (6) is shown on the left side of the screen and the
signal on the "right" DVI connector (7) is shown on the right side
of the screen. The video resolution of both signals must not
exceed 1280x1600 pixels if you wish to display both signals
seamlessly side by side. If the video resolution is higher, you can
select to display only one input instead of both.
• When only one input is used (Single View), the signal on the
used DVI connector is displayed in the center of the screen. It
doesn't matter which DVI input you use. The video resolution
must not exceed 2560x1600.
Note: For plug-and-play graphic boards (e.g., MXRT-2100) the
output resolution of the graphic board(s) is determined by the
20