Adding The 4-Port Card To Sp B; Rebooting A Sp Assembly Into Normal Mode - Dell EMC Unity 480/F Installation And Service Manual

Service Procedures

Adding the 4-port card to SP B

Rebooting a SP assembly into Normal Mode

Unity 480/F, Unity 680/F, Unity 880/F Installation and Service Guide
60
Figure 50 Locking the release lever
3. Connect each cable into the same port from which it was removed.
You have completed the addition of the 4-port card to SP A. Now you are ready to add
the other 4-port card to SP B by repeating the tasks that you just performed for SP A.
Note
Ensure that you install the 4-port card in the same slot on SP B that was used on SP
A.
Procedure
1. Place SP B into reset and hold.
2. Locate the slot for the new 4-port card on SP B.
3. Remove the embedded module.
4. Install the new 4-port card.
5. Replace the embedded module.
6. Reboot SP B into normal mode.
Before you begin
Ensure that the replacement I/O module, embedded module, or 4-port card has been
correctly installed using Unisphere. The replaced part's status indicates that the
module is powered off and will power on during the next system reboot.
Reboot the recently serviced SP assembly into Normal Mode using the procedure that
follows:
Procedure
1. Open Unisphere and select Service, then Service Tasks.
2. Under the name of the storage processor where you installed the new I/O
module, embedded module, or 4-port card, select Reboot and click Execute.
3. When prompted, type the Service Password to put the SP assembly into
Normal Mode.