Verifying The Operation Of The New Part In Unisphere; Replace A Faulted Sfp; Identifying And Locating The Faulted Part In Unisphere; Remove An Sfp Module - Dell EMC Unity 480/F Installation And Service Manual

Service Procedures

Verifying the operation of the new part in Unisphere

Replace a faulted SFP

Identifying and locating the faulted part in Unisphere

Remove an SFP module

Unity 480/F, Unity 680/F, Unity 880/F Installation and Service Guide
70
Verify that the new part is recognized by your system, and operating correctly.
Procedure
1. In Unisphere, select System View.
2. On the Summary page, confirm that the system status is OK.
3. Select the Enclosures page.
4. Verify that the part appears with the OK status in the enclosure view. You may
need to refresh Unisphere by clicking on the refresh icon next to the
Enclosures view.
If the system health monitor shows the part as faulted, contact your service
provider.
Take the following actions to remove the faulted SFP and install the replacement SFP
into the system.
Before you replace a faulted part, locate its placement within the storage system.
Procedure
1. In Unisphere, select System View.
2. Select the Enclosures page.
3. Locate the faulted part marked orange, and displayed in the Enclosures view.
Procedure
1. If a cable is connected to the SFP, disconnect the cable.
2. Gently pull down on the spring release latch.
3. While still holding onto the latch, gently pull out the SFP module.
CAUTION
Do not remove the I/O module. Removing the I/O module causes the SP
assembly to reboot immediately.