Identify The Location For The New 4-Port Card; Install A 4-Port Card - Dell EMC Unity 480/F Installation And Service Manual

Service Procedures

Identify the location for the new 4-port card

Install a 4-port card

Unity 480/F, Unity 680/F, Unity 880/F Installation and Service Guide
58
Figure 46 Removing the embedded module from the system
4. Remove the embedded module from the slot.
Ensure that you install the new 4-port card in the correct location.
Install the new 4-port card in slot 0 within the embedded module. When looking at the
embedded module from the front, slot 0 is on the left side of the embedded module.
Procedure
1. Remove the air dam at the front of the embedded module.
2. Align the 4-port card in the embedded module so that the ports on the front line
up with the slots on the front of the embedded module.
3. Align the white pegs beneath the holes on the 4-port card.
CAUTION
Do not force the 4-port card into place. If the 4-port card does not
smoothly seat, re-align the pegs and try again.
Figure 47 Seating the 4-port card