Committing The New I/O Ports; Verifying The Operation Of The New Part In Unisphere; Replace A 4-Port Card; Identifying And Locating The Faulted Part In Unisphere - Dell EMC Unity 480/F Installation And Service Manual

Committing the new I/O ports

Verifying the operation of the new part in Unisphere

Replace a 4-port card

Identifying and locating the faulted part in Unisphere

It may take up to 15 minutes for the system to complete its reboot to return to
normal mode.
You must commit the new I/O ports before they can be used.
Procedure
1. In Unisphere, select System View.
2. Select the DPE and select Commit IO Ports.
Note
Committing I/O ports requires multiple reboots of the SPs and may take up to
an hour to complete. You can find I/O ports commit and SP reboot status
details on Service
Unisphere connectivity.
After this process completes, the new I/O ports have been successfully
committed into the system.
If the commit of the new I/O ports fails, please wait 15 minutes for the system
to fully boot and then re-attempt the commit process.
Verify that the new part is recognized by your system, and operating correctly.
Procedure
1. In Unisphere, select System View.
2. On the Summary page, confirm that the system status is OK.
3. Select the Enclosures page.
4. Verify that the part appears with the OK status in the enclosure view. You may
need to refresh Unisphere by clicking on the refresh icon next to the
Enclosures view.
If the system health monitor shows the part as faulted, contact your service
provider.
Take the following actions to remove the 4-port card and install the replacement 4-
port card into the system.
Before you replace a faulted part, locate its placement within the storage system.
Procedure
1. In Unisphere, select System View.
2. Select the Enclosures page.
3. Locate the faulted part marked orange, and displayed in the Enclosures view.
Logs. During these reboots you will temporarily lose
>
Service Procedures
Committing the new I/O ports
61