Table of Contents
Advertisement
5. To change the system time zone, enter:
# config set timezone US/Central
The Timezone name is: US/Central
*** You made a change to the timezone setting.
*** (in currently running processes), you need to reboot the machine.
6. Reboot the primary node for the time zone change to take effect:
# system reboot
The 'system reboot' command reboots the system. File access is interrupted during the
reboot.
Are you sure? (yes|no|?) [no]: yes
ok, proceeding.
The system is going down for reboot.
7. After the system completes the reboot, login again as sysadmin using the serial number as a password. Press Ctrl-C to
get through the EULA, sysadmin password prompt, and config setup wizard.
8. Generate an autosupport sent to yourself to use as ACG input:
# autosupport send your.email@emc.com
OK: Message sent.
9. Generate an ACG using the produced ASUP.
Configure HA for new installations
Prerequisites
● The HA interconnect between both nodes is connected.
● The data connections on both nodes are connected.
About this task
Configure the two nodes as an HA pair.
NOTE:
Configuring an HA pair sets the system password on the standby node to match the system password on the active
node, however, that synchronization is not set until the HA configuration is complete. If the HA configuration fails, or if
there is a need to access either node before the HA configuration is complete, use the serial number of each node as the
password.
Steps
1. Verify the certificate subject name on the primary node.
Run the following command: adminaccess certficate show
sysadmin@dd-ha3a# adminaccess certificate show
Subject
Until
--------------------------
------------------------
dd-ha3a.example.com
21:11:28 2022
dd-ha3a.example.com
21:04:53 2024
--------------------------
------------------------
2. Verify the certificate subject name on the standby node.
Run the following command: adminaccess certficate show
sysadmin@dd-ha3b# adminaccess certificate show
Subject
--------------------------
------------------------
dd-ha3b.example.com
22:11:28 2022
84
Configure System for Use
Type
Application
----
-----------
host
https
ca
trusted-ca
----
-----------
Type
Application
----
-----------
host
https
To fully effect this change
Valid From
------------------------
Tue Aug
8 14:11:28 2018
Tue Aug
8 21:04:53 2018
------------------------
Valid From
------------------------
Tue Aug
8 15:11:28 2018
Valid
Sat Aug
7
Mon Aug
7
Valid Until
Sat Aug
7
Advertisement
Table of Contents
