System Connection - Renishaw TONiC T103 Series Installation Manual

System connection

Approved ESD precautions must be followed at
all times during readhead and interface electrical
connections. The readhead is connected to the
Ti / TD interface via a small, rugged connector to
allow for easy feed-through during installation.
Connecting the readhead
1
Remove the cover plate as shown
(2 × M2.5 hex head screws).
2 Taking care not to touch the pins, plug the
connector into the socket in the interface,
ensuring correct orientation as shown.
3
Refit the cover plate ensuring the cable ferrule is located in the recess on the inside and no wires are trapped under the cover plate.
TONiC RKLC20-S linear installation guide
Disconnecting the readhead
1 Remove the cover plate on the interface
(2 × M2.5 hex head screws).
2
Gently lever the connector PCB
(on the end of the cable) out of the socket.
Do not pull the cable to remove
the connector.
3
Place the connector in an anti-static bag.
4
Refit the cover plate.
9