Connect A Usb Cable - Motorola RD5000 Integrator Manual

1 - 10 RD5000 RFID Integrator Guide

Connect a USB Cable

The USB port is protected by the USB port cover. To access the USB port, remove the USB port cover.
CAUTION
Loosen the two phillips head screws and lift off the USB port cover (see
1.
Phillips
Head
Screws (2)
USB Port
Cover
Remove the USB Port Cover
Figure 1-6
Connect the USB cable to the reader as shown in
2.
USB
Cable
Connect the USB Cable
Figure 1-7
With the USB port cover removed the reader should only be operated in a clean, dry environment (for
setup and configuration only). The USB port cover must be replaced before operating the reader
outside of a lab environment. With the USB port cover removed the reader is not properly sealed.
Figure
USB
Connector
Figure 1-7.
1-6).
USB
Connector