Update Method 2, Direct Connect Over The Ethernet Port - Motorola XR450 - RFID Reader - Contactless Integration Manual

Update Method 2, Direct Connect Over the Ethernet Port

Use this method if a reader that is not on a LAN needs to be updated.
Use the serial Administrator Console, to disable DHCP on the reader, and configure it for a static IP address
1.
(192.168.1.3)
Configure the host computer to reside on the same subnet as the reader.
2.
Open Network Connections and locate the connection that will be used to connect to the reader.
a.
Open the TCP/IP connection properties, the TCP/IP Connection Properties screen appears. Change to
b.
use a static IP address that is on the same subnet as the reader (192.168.1.5). Click OK.
TCP/IP Connection Properties Screen
Figure B-3
Connect the Cat5 crossover cable from the host computer to the reader.
3.
On the reader to be updated, access the web based Administrative Console:
4.
Open a browser and type http://192.168.1.3 (or the IP address of the reader to be upgraded, if it is not the
a.
default address above). The Reader Administrative Console login screen appears (see
3-2).
Enter the user name and password. If this is the first time accessing the console, a prompt appears for a
b.
user name and password update. The default settings are:
The Console Main Menu appears (see
From the Console Main Menu select Scan Control the Reader Scan Control screen appears (see
5.
on page 3-11).
Select the Enable/Disable Polling button to set to Disable Polling. The button reads Enable Polling if polling is
6.
disabled properly.
Select Maintenance, the Reader Maintenance Console (see
7.
Select Version the Version Control screen appears and displays the current version information (see
8.
4-6 on page 4-7
Username: admin
Password: change
Figure 3-39 on page
and Figure 4-7 on page 4-8).
Firmware Upgrade Procedures
3-44).
Figure 4-1 on page 4-1) appears.
B - 5
Figure 3-1 on page
Figure 3-12
Figure