Motorola RD5000 Integrator Manual page 207

Change the Set Connectibility option to Connectable.
7.
Right click on RD5000; again and go to Settings->Services tab.
8.
Click Add and Add Serial Port service. Set Service name as Serial Port5 and select COM5:
9.
Physical Device Settings Window
Figure 8-39
Click OK to exit and minimize BT Explorer. Do not click the X button this discards the new settings.
10.
Run the RFIDDemo application.
11.
Click the Settings button, in the Tag logging option:
12.
Enter:
Address: COM5:
Port: 5
Speed: 115200
Imp: Uncheck the Log to File option.
Use COM5 as the example port to connect to.
Click OK and exit the RFIDDemo application.
13.
On VRC (or any other terminal):
Use a third party application (such as mobileterminalev_pc_install.exe) to capture data. This is a third party
application from internet (used in this example). Any similar application can be actually used.
Pre-requisite: Install the demo application mobileterminalev_pc_install.exe on remote device (VRC is being
1.
used as an example, where the tag data is to be received). Active sync to VRC and run the
mobileterminalev_pc_install.exe application on the PC. Complete installation steps on your device. The
application will appear on your device in Start->Programs->Mobile Terminal EV.
From BT Explorer icon in right bottom corner of the screen, click Enable Bluetooth.
2.
Run the Mobile Terminal EV application on VRC device from Start->Programs.
3.
NOTE If the app has already been configured accordingly for BT, Go to menu Comm->Open port and proceed
directly to step 8
Go to Comm->Properties. Select port as COM5 and baud rate as 115200. Click OK.
4.
Go to Comm->Open port.
Bluetooth Setup 8 - 31