Barco F70 Service Manual page 90

Troubleshooting
Code E0000301: "Mainboard FPGA temperature exceeded" (Error)
For this error the same troubleshooting table can be applied to as for code E0000101: "Mainboard sensor
temperature exceeded".
Code E0000401: "Mainboard Scaler FPGA temperature exceeded" (Error)
For this error the same troubleshooting table can be applied to as for code E0000101: "Mainboard sensor
temperature exceeded".
Code E0000500: "Barometric pressure lower limit reached" (Error)
Situation
Environmental pressure not
within range as normally
supported by the projector.
Code E0000501: "Barometric pressure exceeded" (Error)
Situation
Environmental pressure not
within range as normally
supported by the projector.
Code E0000700: "Humidity too low" (Error)
Situation
Wiring issue
Malfunction humidity sensor
(return value = 0)
Code E0000701: "Humidity exceeded" (Error)
Situation
Environmental humidity too
high.
Code E1000101: "LaserDriver A bank 1 temperature exceeded" (Error)
Situation
This error appears alone:
Lasersource bank 1 NTC
temperature exceeded due to
insufficient cooling of light
source.
Error appears alongside other
Cooler related errors.
90 723–0018 /02 F70
Solution
Ensure that environmental conditions comply with the operation
requirements of the projector. See installation manual of the projector for
detailed installation requirements.
Solution
Ensure that environmental conditions comply with the operation
requirements of the projector. See installation manual of the projector for
detailed installation requirements.
Solution
Verify the connection toward the humidity sensor.
Replace the sensor.
Solution
Ensure that environmental conditions comply with the operation
requirements of the projector. See installation manual of the projector for
detailed installation requirements.
Solution
Check the tube connections between both the cooler(s) and the light
source. Make sure the tubes are properly connected and check for liquid
spills or leakage.
Resolve cooler related errors first.