Fixing Connections / Hygiene P - Pentair SPEEDEO SB-PF-SPO-003C Installation And User Manual

Wall fixing
- This device is intended to be used inside, installed in a technical room which cannot be accessed by
children.
- Set the device at a height lower than 2 m using three screws (4 to 5 mm diameter) in appropriate plugs
for the type of support and fix the device vertically on a clean support which is able to bear a minimum
vertical load of 5 kg.
Pierce three holes in accordance with the below dimensions then place 3 suitable plugs.
1 - Tighten the screw at the top, leaving 2 mm under the screw head, then hang the device on this.
2 - Place the 2 lower screws.
3 - Add the 2 lower screw covers to ensure a full seal.
1
A safety cover which cannot be unclipped without a tool is positioned above the connectors which provide
the voltage. > Place a flat screwdriver on the flat part of clips 2 and 3, while keeping pressure on to unclip it.
1
2
2
After each intervention, replace the
orange safety cover then the flexible
grey cover.
4
3
3
07