Device Description - WAGO I/O-SYSTEM 750 Series Manual

WAGO-I/O-SYSTEM 750
750-613 24V DC Power Supply (Bus)
3

Device Description

The I/O module 750-613 (24V DC Power Supply (Bus)) provides the internal
system power to the downstream modules and increases the system current supply
by 2 A.
Furthermore the I/O module 750-613 provides galvanically isolated DC 24 V field
side power to the downstream modules.
Resetting the system by switching on and off the system supply
Resetting the system by switching on and off the system supply must take place
simultaneously for all supply modules (field bus coupler/controller and system
supply modules 750-613)!
The system power supply is connected to the upper 24 V/0 V CAGE CLAMP
connectors in parallel to the field bus coupler/controller.
The field power supply is derived from an external source via the lower CAGE
®
CLAMP
The assignment of the connections is described in the "Connectors" section.
2 green status LEDs indicate the status of the system supply voltage and the field
s
supply voltage.
The meaning of the LEDs is described in the "Display Elements" section.
The I/O module provides the 24V, 0V and earth potential to subsequent I/O
modules via the power contacts used as spring contacts.
Do not exceed maximum current via power jumper contacts!
The maximum current to flow through the power jumper contacts is 10 A.
Greater currents can damage the contacts.
When configuring your system, ensure that this current is not exceeded. If
exceeded, insert an additional supply module.
The I/O module 750-613 can be used with all fieldbus couplers/controllers of the
WAGO-I/O-SYSTEM 750.
Operation in shipbuilding or offshore and onshore applications
The supplementary power supply regulations (see section "Connect Devices" >
"Power supply concept") must be observed for the certified operation of the
supply module 750-613 in shipbuilding or offshore and onshore applications!
Manual
Version 1.1.0
connectors 24 V, 0 V and ground (earth).
Device Description
®
13