Westerbeke BTDA 15.0 Operator's Manual & Installation Manual page 24

Generator (AC Output)
Make sure that the AC output connections within the generator's AC terminal block are
correct and in acordance with the specific AC Load Connections diagram found later in
this manual. (See the "BT GENERATOR" section of this manual.) Make sure the AC
leads are protected against chafing as they exit the generator housing
IWARNiNGI
Do not smoke or allow an open flame near batteries. Lead acid batteries emit
hydrogen, a highly-explosive gas.
Batteries
Make sure the positive (+) battery connection is connected to the battery connection of
the starting solenoid. The negative (-) battery connection should be connected to the
ground stud tagged at the rear of the engine block.
!WARNiNGJ
Protect Yourself When Servicing The Battery
When servicing the battery of checking the electorlyte level, wear rubber gloves, a
rubber apron, and eye protection. Battery acid may splash on the skin or into the
eyes inadvertently when removing the electrolyte caps.
Check the battery's electrolyte level and specific gravity to ensure maximum engine
starting efficiency. Make sure the battery's terminals are clean and tight.
Westerbeke Generators
22 15.0KW BTDA