Pc Connection; Network Setup - UTC UDI-14 User Manual

PC Connection

Use the PC Connection option to connect UDI-14™ to your PC and use it with the DiveSim™ application.
See page 48 for information on using DiveSim™.
WARNING: Do not enter the water with the UDI-14™ when the "PC connection" is active. This will
damage your UDI-14™.
NOTE: When the PC connection has not been used for 2 minutes, it becomes disabled to prevent any
damage to the UDI-14™ in case you forget to disable the PC connection option.
To use PC Connection:
1. Connect the quick connector to the UDI-14™
2. Connect the USB cable to the quick connector.
3. Connect the USB cable to the PC computer.
4. On the UDI-14™ Setup menu, select PC Connection.
5. Select Enable press
Enter to enable the
PC Connection. A PC
indication appears at
the bottom right
corner of the display
while the UDI-14™ is
connected to the PC.
NOTE: Updating users list and messages list is done using the DiveSim™ software provided with your
DiveSim™ software
system. See

Network Setup

Use this option to select User and Buddy numbers; and a network.
NOTE: You and your buddy must be properly defined on your UDI-14™ and your buddy's UDI-14™
respectively, and you must both be on the same network to be able to communicate using the
UDI-14™.
1. Select Net to define a network
to use, and press Enter.
on page 48 for details.
NETWORK SETTING
4. Setup
1. Net
2. User
22