Table of Contents
Advertisement
Remote SOS
UDI-14™ contains the ability to send a remote SOS signal to another user.
Failure to respond to the request within 15 seconds by the user receiving a remote SOS causes the
UDI-14™ to start sending SOS signal to the entire network. You will receive an SOS signal and navigate
to the diver in distress.
The remote SOS signal takes the form of a message that cannot be modified or deleted from the message
list.
To activate the remote SOS:
1. In the Message menu, select
Remote SOS from the list by
scrolling with the Up/Down
buttons, then click Enter.
2. Click Send. The message is
sent.
Mask Homing
You can temporarily mask the navigation homing beacon to prevent your UDI-14™ from sounding a
homing alarm when a homing signal is transmitted. This allows you temporarily disregard the homing
signal until the time you need it to return to the boat station.
NOTE:
Masking the homing beacon
To mask a homing beacon:
1. From the Navigation menu,
select Mask Homing and
press Enter.
2. In the Mask Homing menu,
select Enable to mask the
beacon and press Enter.
When you enable Mask Homing,
a small M is shown in the lower
right corner of the display.
.
does not
mask any SOS beacons that may be activated during a dive.
15.4
depth
32.0
dive time
max
24
124
No deco
36
25
M
Advertisement
Table of Contents
