Table of Contents
Advertisement
Units
Use this option to select Metric units (meters, degrees centigrade) or Imperial units (Feet, degrees
Fahrenheit) as your unit of measurement.
Select Imperial or Metric and press
Enter. All units displayed on the
UDI-14™ boat unit will now
conform to the unit type chosen.
NOTE: The temperature displays according to your units selection – When you select Feet, Fahrenheit
degrees are shown, when you select Meters, centigrade degrees are shown.
About UDI-14™ boat unit
Use this option to view the UDI-14™ boat unit serial number, and software version installed. Use this
information when contacting UTC about your UDI-14™ Boat unit.
In addition the About UDI screen presents the table tag value which is a unique code for each specific
UDI-14™ list of users and messages. Make sure that every UDI-14™ device and boat unit (in the same
network) has the same Table Tag value. For more information see page 5
For more information on table tag refer to page 5.
Care and maintenance
The UDI-14™ boat unit requires very little care or maintenance.
After every dive: wash the antenna and antenna cable. Wipe down the UDI-14™ boat unit and make
sure that the connectors are well covered (using caps) and are dry prior to connecting the UDI-14™ boat
unit to the charger or the PC.
Do not use a water jet or pressure from hose to clean the UDI-14™ boat unit, to prevent damage to the
UDI-14™ boat unit mechanism.
Periodically the UDI-14™ boat unit may need to be serviced at an authorized laboratory for calibration
and battery replacement (Consult the UDI™ webpage for information).
Revert to factory setting
In case you would like to revert to the original UDI-14™ boat unit factory settings, press the Up, Down
and Enter buttons simultaneously. Wait for the UDI-14™ boat unit to turn on and for the message "set
default" appears on the screen. All customizations and settings you have done will be erased, and UDI-
14™ boat unit will turn on with the original factory settings.
47
Advertisement
Table of Contents
