Sound Active Mode; Display Timeout; Display Invert; Pan/Tilt Invert - Blizzard Lighting LOOP Manual

Sound Active Mode:

1.) Navigate the main menu until you reach Run Mode, press <ENTER>.
2.) Use the <UP/DOWN> buttons to highlight Sound Active 1 or 2.
3.) Press the <ENTER> button to confirm your selection.
Static Mode:
1.) Navigate the main menu until you reach Intro, press <ENTER>.
2.) Use the <UP/DOWN> buttons to select Static Setup.
3.) Manual adjustments ranging from 0-255 can be made to any available static
mode submenu option.
System Utilities
Other utilities found within the control panel menu.

Display Timeout:

1.) Navigate the main menu until you reach Utilities, press <ENTER>.
2.) Highlight Disp. Setting <ENTER>, then Display Timeout <ENTER>.
3.) Set the timer to shut off the display after 0-60 minutes of inactivity.

Display Invert:

1.) Navigate to Utilities <ENTER>, then Disp. Setting <ENTER>.
2.) Use the <UP/DOWN> buttons to select Display Invert, press <ENTER>.
3.) From here, you can select Normal or Invert to flip the display.

Pan/Tilt Invert:

1.) Navigate to Utilities <ENTER>, then Pan Invert or Tilt Invert <ENTER>.
2.) Use the <UP/DOWN> buttons to highlight Normal, or Invert.
3.) Press the <ENTER> button to confirm.

Calibration Settings:

1.) Navigate to Utilities <ENTER>, then Calibration <ENTER>.
2.) Use the password 169 to enable editing Pan and Tilt values from 0-255.
3.) Press the <ENTER> button to confirm.

Encode (Pan/Tilt Error Correction):

1.) Navigate to Utilities <ENTER>, then Encoders <ENTER>.
2.) Use the <UP/DOWN> buttons to highlight On or Off.
3.) Press the <ENTER> button to confirm.

Fixture Test:

1.) Navigate the main menu until you reach Utilities, press <ENTER>.
2.) Use the <UP/DOWN> buttons to select All (motors and LEDs), Pan & Tilt
(motors), LED (LEDs only), or Ring LED (ring LEDs only.)
3.) Press the <ENTER> button to confirm your selection.

Motor/Factory Reset:

1.) Navigate to Utilities <ENTER>, then Motor or Factory Reset <ENTER>.
2.) Use the <UP/DOWN> buttons to highlight Yes or No.
3.) Press the <ENTER> button to confirm.

Runtime Info

1.) Navigate to Utilities <ENTER>, then Time Info <ENTER>.
2.) Here you can view current Power On time, Total Life, and Last Run hours.
LOOP™ User Manual - Rev. A
Page 13
(c) 2017 Blizzard Lighting, LLC