Control Panel Menu Structure; Dmx Mode; Master/Slave Mode; Sound Active Mode - Blizzard Lighting switchblade User Manual

Control Panel Menu Structure

NOdE Addr VALU
SLAU
SOUN 1P01
1P08
AUTO 1P01
1P08
rESt ON
OFF
dN11 NOd1
NOd2
SEt NIC N-00
VEr U-10
LOdA

DMX Mode

Allows the unit to be controlled by any universal DMX controller.
1.) The default mode for the fi xture is DMX, which appears as
select a different DMX address, using the <MENU> button, select
Addr
select ,then hit <ENTER>, then select
DOWN> buttons to select the correct address, then hit <ENTER> to confi rm.
Setting the DMX Channel Mode:
1.) To select a DMX channel mode, press the <MENU> button, then use the <UP> or
<DOWN> buttons until the display reads
the <UP> or <DOWN> buttons to select
NOd2
or select
Sound Active or Auto Modes
1.) To select Sound Active or Auto mode, using the <MENU> button, select
<ENTER>, then using the <UP/DOWN> select
AUTO
(for Auto Mode) then hit <ENTER>. At this time you will be given the chance to select
one of the 8 pre-programmed macros. Use the <UP/DOWN> buttons to select the pro-
grammed sequence you would like to run, then hit <ENTER> to confi rm.
SwitchBlade™ Manual Rev. A
A001 A512
ALON SO-A
NASt S0-N
ALON A0-A
NASt AO-N
N-99
ON
OFF
and press <ENTER> for 10 channel mode.
Page 11
Choose fi xture DMX address
Set fi xture to Slave mode
Run the fi xture in sound active mode
Run the fi xture in S/A single/alone mode
Run the fi xture in Master for S/A mode
Run built-in programs
Run Macros in single/alone mode
Run Macros in Master for Master/Slave mode
All reset
12 Channel DMX mode
10 channel DMX mode
Mic sensitivity
Software Version
Reload data
A001
NOdE
VALU
,then hit <ENTER>. Use the <UP/
dN11
and press the <ENTER> button. Then use
NOd1
and press <ENTER> for 12 channel mode,
SOUN
, (for Sound Active mode) or select
© 2014 Blizzard Lighting, LLC
on the LED Readout. To
,then hit <ENTER>,
NOdE
, then hit