Table of Contents
Advertisement
If you keep holding the THRESHOLD button, then during the next two seconds
the radiometer will proceed to the submode of programming of new values of alarm
threshold level and specified statistical error, and switching on/off audio signaling
of registered gamma-quanta (Figure 7). A stripe (1) "moving" across the
instantaneous value indicator and blinking of the low-order digit (2) of a new
threshold level serve as an indication of this submode. Then release the
THRESHOLD button.
When a digit is blinking, it means that its value can be programmed. Use the
THRESHOLD button to set the required value of the blinking digit. Successive short
presses and releases of the THRESHOLD button change this value per unit. A long
press of the THRESHOLD button starts automatic change of this value, which is
stopped after the button is released.
43
Advertisement
Table of Contents
