2.2.3.2 Press shortly the MODE button and make sure the radiometer enters the
mode of surface beta-particles flux density measurement. "β" symbol and "
3
" dimension of the measured quantity show that the radiometer is
10
2
(
cm
min)
operating in this mode.
2.2.3.3 Press and hold (circa 6 seconds) the MODE button until the radiometer
turns off.
2.2.4 List of possible troubles and troubleshooting
2.2.4.1 The list of possible troubles and troubleshooting is presented in Table
2.2. Troubles during use are recorded in Appendix D of this OM.
2.2.4.2 At failure to eliminate the troubles presented in Table 2.2, or at detection
of more complicated troubles, the radiometer should be sent for repair to the
manufacturer.
25