Main Board Connection Or Replacement - MUTOH ValueCut VC-600 Maintenance Manual

Main board Connection or Replacement

Main board connection or replacement must follow the following steps to be sure that no damage
comes to either service personnel or the components:
Note1: To ensure absolute safety for service personnel and components, please follow the safety
instruction at the beginning of this manual, before installing or replacing any current
carrying components
T Parallel Port Connector o unplug the jumpers and connectors from the main board
X motor power
Fan X motor encoder
1. Unplug all of the jumpers and connectors attached to all off board components.
Note: Please refer to the Wiring Diagram for more detail on jumper and connector attachment
VCE-MM-02
Power Board jumper
Front paper sensor
Rear paper sensor
Com port extend jumper
Flat cable to carriage
30
MAINTENANCE MANUAL
X motor power
X motor encoder
Level Switch Jumper
Control Panel
USB Extend jumper