MUTOH ValueCut VC-600 Maintenance Manual page 31

1. Unscrew and remove the 5 restraining screws, and the pop out support to completely
remove the main board.
Note: To install or replace the main board simply reverse the steps to remove it.
Note: Main board attachment position changed as below (refer to the below image) from the "Serial
Interface connector (RS-232C) 9pin type
Remove the X motor before replacing the Main board.
VC-600
VC-1300
VC-1800
VCE-MM-02
machines.(Serial see below)
EVC2U0070~
EVC5U0068~
EVC7U0112~
31
MAINTENANCE MANUAL