Main Menu > Parameter > Alarm > Motion - KGuard Security HD Series User Manual

This menu allows you to configure motion parameters. The motion detection is pretty straight forward, the DVR simply compares one frame to another. A sufficient amount
of difference is interpreted as motion. When the motion is detected, the system can be set to automatically initiate recording. In this menu you can select the channels
where you want the motion based recording to take place.
By default, the whole screen is marked for motion detection (red blocks). If you want to disable the motion detection on an area, you need to click the grid cursor and then
drag the mouse to highlight the scope to unmark the area (transparent block).
If you set the motion detection at a high sensitivity level ("8" is the most sensitive) then the frequency of false alarm events increases. Vice versa if the sensitivity level is
too low ("1" is the least sensitive), you might increase the risk that a significant motion event will not trigger the motion detection to record.
• Send Email: You can let the DVR to send you an auto-email when
the motion is detected. To set up the email schedule, please see
"Main Menu > Parameter > Network > Email & Email Schedule" on
page 23.
• Full Screen: If this function is enabled and a motion is detected in
a channel, you will see that channel in full screen.
• Analog Channels / IP Channels: Here you can select which
channels you want to include to the motion detection. If the
motion is detected, the recording will start immediately on those
channels.
Main Menu > Parameter > Alarm > Motion
• Channel:
• Enable:
• Buzzer: The DVR can use its internal buzzer to emit an alarm tone. You can set the buzzer duration
in seconds when the motion is detected.
• Sensitivity: Set the sensitivity level.
• Post
The recommended recording length is 30 seconds but it can be set higher up to 5 minutes.
• Show
• Area: To setup motion area, click Setup.
Select the channel you want to set the motion detection.
Enable or disable the function.
Recording: You can set how long after an event occurs that the DVR will continue to record.
Message: Check the box to display " " icon on the screen when the motion is detected.
M
Area is unmarked
Hybrid DVR (HD Series)
25