Mvme162P2 Configuration; Table 1-2. Mvme162P2 Configuration Settings - Motorola MVME162P2 Series Installation And Use Manual

MVME162P2 Configuration

Figure 1-1
configuration switches, and various other components on the
MVME162P2. Manually configurable jumper headers and configuration
switches on the MVME162P2 are listed in the following table.

Table 1-2. MVME162P2 Configuration Settings

VME System Controller (J1) on page 1-7
IP Bus Strobe (J11) on page 1-7
SCSI Termination (J12) on page 1-8
IP Bus Clock (J13) on page 1-9
SRAM Backup Power Source (J14) on page 1-10
Flash Write Protection (J16) on page 1-11
EPROM/Flash Configuration (J20) on page 1-11
MC2 DRAM Size (S3) on page 1-15
General-Purpose Readable Switch (S4 Pin 5) on page 1-16
IP DMA Snoop Control (S5 Pins 1/2) on page 1-18
IP Reset Mode (S5 Pin 3) on page 1-19
Flash Write Enable Mode (S5 Pin 4) on page 1-20
MCECC DRAM Size (S6) on page 1-21
J15 (also J24, if present) is a PLD programming header for lab or factory
use. It has no user function.
http://www.motorola.com/computer/literature
illustrates the placement of the jumper headers, connectors,
Function
Preparing the Board
Factory Default
2-3
No Jumper
Jumper On
1-2
1-3, 2-4
Jumper On
5-6, 9-11, 8-10
Off-Off-Off
On
On-On
On
On
On-Off-On
1-5
1