Connectors; Remote Status And Control; Chapter 5 Pin Assignments - Motorola MVME162P2 Series Installation And Use Manual

Functional Description

Connectors

4

Remote Status and Control

4-18
The MVME162P2 has two 96-position DIN connectors: P1 and P2. P1
rows A, B, C, and P2 row B provide the VMEbus interconnection. P2 rows
A and C are not used.
The serial ports on the MVME162P2 are connected to four 8-pin RJ45
female connectors ( J17) on the front panel. The two IP modules connect
to the MVME162P2 by two pairs of 50-pin connectors. Two additional 50-
pin connectors behind the front panel are for external connections to IP
signals. The Ethernet LAN connector (J9) is a 15-pin socket connector
mounted on the front panel. The SCSI connector (J23) is a 68-pin socket
connector mounted on the front panel.
Pin assignments for the connectors on the MVME162P2 are listed in
Chapter 5.
The remote reset connector, J2, is a 20-pin connector located behind the
front panel of the MVME162P2. It provides system designers with
flexibility in accessing critical indicator and reset functions. When the
board is enclosed in a chassis and the front panel is not visible, this
connector allows the Reset, Abort, and LED functions to be extended to
the control panel of the system, where they are visible. Alternatively, it
allows a system designer to construct a
be located remotely from the MVME162P2.
/ /LED panel that can
RESET ABORT
Computer Group Literature Center Web Site