Hardware Preparation and Installation
1
SCSI Termination (J12)
1-8
If the jumper is removed from J11, the strobe line is available for a
sideband type of messaging between IP modules. The Strobe∗ signal is not
connected to any active devices on the board, but it may be connected to a
pull-up resistor.
J11
2
1
IP Strobe disconnected
(Factory configuration)
The MVME162P2 provides terminators for an SCSI bus. The SCSI
terminators are enabled/disabled by a jumper on header J12. The SCSI
terminators may be configured as follows.
J12
2
1
Onboard SCSI Bus Terminators disabled
Note
If the MVME162P2 is to be located at either end of an SCSI bus,
the SCSI bus terminators must be enabled.
J11
2
1
IP Strobe connected
J12
2
1
Onboard SCSI Bus Terminators enabled
(Factory configuration)
Computer Group Literature Center Web Site