Fuses - KSR Moto TRIGGER 50 Repair Manual

ELECTRICAL SYSTEM/ FUSES/ SWITCHES

FUSES

The main fuses (1) are located next the battery. In the fuse socket
strap a replacement fuse (2) is added.
NOTE
To avoid a short circuit, always set the main switch to "OFF" when
checking or replacing a fuse.
1. Insult a new fuse of the correct amperage rating.
FUSE AMPERE RATING
Main Fuses 10 Ampere
Replacement 10 Ampere
2. Set on the switches to verify if the electrical circuit is opera-
tional.
3. If the fuse immediately blows again, check the electrical cir-
cuit.
! WARNING
Never use a fuse with an amperage rating other than that speci-
fied. Improvising or using a fuse with the wrong amperage rating
may cause extensive damage to the electrical system, cause the
lighting and ignition systems to malfunction and could possibly
cause a fire.
LIGHT AND SWITCHES OPERATION INSPECTION
1. Place the vehicle on the stand and start the engine.
NOTE
Some functions do not work as long the engine is not running.
2. Now you can test one by one the functions of all switches, the
function of the rear and front light and the brake light.
Switches/ Functions - left side
1. High/ Low beam switch/ Flasher
2. Indicator switch
3. Horn switch
Switches/ Functions - right side
4. Starter Button
1
2
1
2
3
4
44