Table of Contents
Advertisement
STEERING
HANDLEBAR REPLACEMENT
In case of any damage of the handlebar you must replace it.
1. Remove the left (1) and right handle switch (2) as described
in the manual.
2. Loosen the four screws (3) and remove the handlebar
clamp (4).
3. Loosen the two screws (5) and remove the right handle
swicht by sliding to the right. If the wires are too short, put
the handlebar to the left.
4. Remove the two screws (6) of the front brake clamp (7) to
remove the front brake lever . It is not necessary to remove
the rear view mirror.
NOTE
If you remove the front brake handle do not apply the brake as
pulling the brake in a non horizontal position of the brake system
could let air get into the brake system which would lead to a loss
of brake pressure.
1
4
3
7
6
108
2
5
Advertisement
Table of Contents
