Table of Contents
Advertisement
ELECTRICAL SYSTEM/ SPEEDOMETER
SPEEDOMETER DESCRIPTION
1. Speedometer
2. Engine coolant tell-tale
3. Engine oil tell-tale
4. Main-beam headlamp tell-tale
5. Dipped-beam headlamp tell-tale
6. Direction tell-tale
7. Neutral tell-tale
8. Odometer
SPEEDOMETER REPLACEMENT
1. Remove the headlight before removing the speedometer.
2. Remove the two screws on the left and right side to discon-
nect the headlight bracket and the speedometer bracket.
3. Disconnect the cables (1).
4. Unscrew the six hexagonal (2) bolts from underneath.
5. Replace the whole instrument panel if necessary.
6. Install the instrument orderly in the reverse order of removal.
!
WARNING
It is not possible to repair the Instrument panel.
If you face any defect of the panel please replace the whole In-
strument.
IGNITION SWITCH INSPECTION
1. Remove the headlight.
2. Disconnect the ignition switch plug.
3. Use a continuity tester to measure the ignition switch (1) as
shown in the illustration.
4. If the main switch does not work correct replace it.
"
" (OFF) position: All the circuits are broken.
" " (ON) position: Ignition circuit is switched on and engine can
be started. When the switch is at this position, the key cannot be
pulled out.
IGNITION SWITCH REPLACEMENT
1. Remove the headlight.
2. Disconnect the ignition switch plug.
3. Remove the two bolts (1).
4. Assembly in reverse order.
STEERING LOCK
1. The steering lock (2) is located in the ignition switch.
2. If the steering lock does not work correct, replace the ignition
switch (see above).
1
8
1
2
1
2
134
2
3
4
5
6
7
Advertisement
Table of Contents
