Left Handle Switch Inspection - KSR Moto TRIGGER 50 Repair Manual

ELECTRICAL SYSTEM/ INSTRUMENTS

LEFT HANDLE SWITCH INSPECTION

1. Remove the headlight.
2. Disconnect the cables of the left handle switch as shown in
the picture (1).
3. Use a continuity tester to measure the switches as shown in
the illustrations below.
4. In case of damage the handle switch need to be replaced.
Flash light switch
Dimmer switch
High beam switch
Horn
Winker left
Winker right
LEFT HANDLE SWITCH REPLACEMENT
1. Remove the headlight.
2. Disconnect the cables of the left handle switch.
3. Remove the screw (1) of the left handle switch.
4. Lift the left handle switch (2) in the height and pull it back-
wards.
5. Assemble the new handle switch in reverse order.
WARNING
!
Watch out, not to bend or twist the cable.
RIGHT HANDLE SWITCH INSPECTION
1. Remove the headlight.
2. Disconnect the cable of the left handle switch as shown in
the picture (1).
3. Use a continuity tester to measure the switches as shown in
the illustrations below.
4. In case of damage the handle switch need to be replaced.
Purple
Startor
Green / Black Brown
Green / Yellow
Blue Light Blue Pink
1
Black Orange Green / White
1
2
1
136
Red / White