Table of Contents
Advertisement
ENGINE/ CLUTCH
2. Check the following items if the compression pressure is too
high.
•
Carbon deposition in combustion chamber or on the top
of the piston.
TROUBLESHOOTING
FAILURE
Cylinder pressure below the allowable
limit
Cylinder pressure higher than the allow-
able limit
CLUTCH CABLE FREE PLAY ADJUSTMENT
The clutch system is operated by a steel cable. By adjusting the
steel cable, the clutch can be set. Check clearance of clutch ca-
ble.
1. Operate
the
clutch
The free play (A) between the 0 position and the pressure
point must be 10 to 15 mm. When free play is higher or lower
the clutch cable need to be adjusted.
2. To adjust the cable loosen the locknut (1) turn the adjustment
nut (2) in or out till the free play of the lever is ok.
3. Tighten the locknut.
Allowable limit: A= 10 - 15 mm
NOTE
If the clutch cable free play cannot be obtained on the handlebar
side of the clutch cable, use the adjusting nut on the engine side.
ADJUSTING THE CLUTCH CABLE FREE PLAY ON THE
ENGINE SIDE
1. To adjust the cable loosen the locknuts (1).
2. Turn the adjustment nut (2) in or out till the free play of the
lever is ok.
3. Tighten the locknuts.
CAUSE
Worn piston ring or cylinder
Defect gasket
Carbon deposition in combustion chamber
or piston
lever
until
pressure
builds.
TO DO
Check the carburettor
Clean or replace the fuel filter
Remove the deposition or replace the
affected parts
2
1
1
2
29
Advertisement
Table of Contents
