Table of Contents
Advertisement
ELECTRICAL SYSTEM/ IGNITION SYSTEM
REGULATOR - RECTIFIER INSPECTION
Disconnect the plug from the regulator rectifier.
Check continuity between main wiring terminals in the following
way.
Multimeter
-
+
White (W)
Red (R)
Pink (PK)
Black (B)
Item (wire color)
Between battery positive (red)
and body ground
Between battery negative (black)
and body ground
Between charging coil (white)
and body ground
Between charging coils (white 1, 2 and 3)
and body ground
GENERATOR CHARGING COIL
Inspection:
Conduction test between generator and vehicle ground:
1. Use a multimeter for a check between the white cable of the
generator and vehicle block.If there is conduction at any of
the white cable the generator has to be replaced.
Charging test:
1. Start the engine and run the engine on idle.
2. Measure the voltage between the white cables of generator
and vehicle block.
3. The voltage at idle speed should be above 30V.
NOTE
Switch to alternating current on your multimeter to measure the
Voltage of Generator.
!
WARNING
Inspection of alternator charging coil can be performed on the
engine.
For the generator replacement please check Engine
disassembling and assembling manuel.
White (W) Red (R)
Unit: MΩ
27.04
0
21.35
0
5.07
22.68
-> Battery voltage
-> Lead wire
-> No power flowing
-> Resistance between the coils
Pink (PK)
Black (B)
15.15
25.40
0
0
22.33
3.63
Judging Method
121
PK
R
B
W
Advertisement
Table of Contents
