Table of Contents
Advertisement
ELECTRICAL SYSTEM/ IGNITION SYSTEM
IGNITION SYSTEM
PREPARATORY DATA
Precautions on operation
1. Ignition system inspection: Please perform inspection in the
sequence listed in the fault diagnosis table.
2. Ignition system uses electronic-type automatic timing de-
vice, which is solidified in the CDI assembly, so it is unnec-
essary to adjust the ignition time.
3. Ignition system CDI shall not be dropped and hung, or heav-
ily knocked (this is also the main reason for its failure). Pay
special attention to this while removing it.
4. Most of the ignition system problem due to poor contact of
sockets. Please check first if parts of the connector are well
contacted.
5. Check if heat value of spark plug is proper. Improper spark
plug may result in unsmooth engine running or burn of spark
plug
6. The maximum voltage is taken to introduce inspection items
in this Part. Inspection methods for impedance value of igni-
tion coil are also recorded and judged.
7. Check ignition switch according to the continuity test table.
8. Remove magneto and stator on operation instructions.
122
Advertisement
Table of Contents
