Fuel System Air Cleaner - KSR Moto TRIGGER 50 Repair Manual

FUEL SYSTEM
AIR CLEANER
Replacement of the air filter element.
1. Remove the seat and the covers on the left side (1).
2. Remove the five mounting bolts (2) and the cover (3)
remove the air cleaner element (4).
3. Assembling in reversed order.
Check to see if the filter element is polluted or damaged. If it is
polluted or damaged, please replace with a new one.
CHANGING INTERVALS
If the motorcycle is frequently driven on bad road or in rain, it
should be replaced early. Under normal condition replace it refer-
ring the maintenance chart.
NOTE
Please note that it is a paper element. Do not use any air filter oil
or other to protect or clean the element. Use only appropriate air
pressure to clean the element.
THROTTLE WIRE INSPECTION/ ADJUSTMENT
Check the smoothness of accelerator pull wire.
Free displacement: 5-10 mm
NOTE
The main adjusting position is on the throttle grip.
1. To adjust the free play of the throttle grip loosen the fixing nut
(2) and adjust by turning adjusting nut (1).
2. After the adjustment is done tighten the nut (2).
The second adjusting position is on the carburettor.
1. To adjust the free play of the gas wire loosen the fixing nut (4)
and adjust by turning adjusting nut (3).
2. After the adjustment is done tighten the nut (4).
NOTE
When the gas wire work sluggishly check if it is damaged or rusty.
Replace it if worn or grease it with silicone spray if it is rusty.
1
to
3
4
2
2
1
3
4
21