Specification - KSR Moto TRIGGER 50 Repair Manual

ELECTRICAL SYSTEM/ FUSE/ BATTERY
FUSE REPLACEMENT
If the fuse is burned out, find the cause and repair it. The fuse
holder is located beside the battery below the seat.
1. Turn off the main switch and all electrical circuits.
2. Remove the seat.
3. Replace the blown fuse (1) and then install a new fuse of the
specified amperage.
! WARNING
Do not use a fuse of a higher amperage rating than recommen-
ded to avoid causing extensive damage to the electrical system
and possibly a fire.

SPECIFICATION

ITEM
Fuses
TROUBLESHOOTING
FAILURE
Fuse blown
BATTERY GENERAL INFORMATION
The battery (1) is located on the right side of the vehicle. It is
recommended to extend the battery whenever it needs servicing.
Disconnect the battery poles (2) to extend the battery.
NOTE
1. The battery can be charged and discharged, and used repeat
edly. If a battery is laid aside after discharging, its service life
will be shortened and its performance is degraded. Perfor-
mance of a battery is usually reduced after about 2-3 years'
run. Voltage of the performance-reduced (capacity drops)
battery can be resumed, but the voltage will run down quickly
while loading.
2. Overcharging of battery: Usually overcharging is demonstrat-
ed by the battery itself. If short circuit occurs inside the bat-
tery, there will be no voltage or very low voltage on the termi-
nals of the battery. Adjuster fails: it indicates too high voltage
on the battery, the life-span of the battery will be shortened.
3. When the battery is not be used for a long period, it will self-
discharge and its capacitance will drop. The battery should
be recharged every two weeks.
4. Charging system inspection: please perform inspection in the
sequence listed in the fault diagnosis table.
5. If there is current going through the electric part, please do
not remove the connector, or the voltage will be very high
and electronic components inside the voltage adjuster will be
damaged. Set ignition switch at "Off" position and then begin
your operation.
DESCRIPTION
Two glass tube fuse
CAUSE
Electrical circuit shorted
Electrical circuit is overloaded
VALUE
10 A
TO DO
Find the cause and repair it. Replace
the blown fuse.
Find the cause and repair it. Replace
the blown fuse.
1
2
1
118