Prn-Id Printer - Honeywell Notifier ID3000 Series Installation & Commissioning Manual

Q
5a
5b
P
O
ID3000 Series Installation & Commissioning Manual
7 Having made the connections described in steps 5

5.5.2 PRN-ID Printer

The printer is supplied one of two ways:
a. For panels with up to 64 or 128 zonal LEDs, the printer
b. For panels with no zonal LEDs, the extension chassis
5.5.2.1 Fitting the Paper Roll
It is recommended that the thermal paper roll is fitted
when the printer is in situ and powered up. The paper
MUST be the right way round - see drawing at left. The
printer will automatically try to take up the end of the
paper roll once it has been inserted into the paper entry
slot (located on the underside of the printer mechanism).
To ensure correct alignment of the paper as it exits the
printer, after fitting, adjustment can be made using the
control located on the left-hand side of the printer:
To fit the thermal paper roll, proceed as follows:
1 Make sure the panel is powered up and the batteries
2 With the paper (M) orientated as shown at left, offer
N
Note: If the printer has a problem with taking up the
M
4
3
3 Support the paper roll and insert the spindle (O),
4 Gently push the paper roll into the slot, then pull it
27
and 6 above, use a Posidriv No.2 screwdriver to
secure the extension chassis.
first has to be fitted to the extension chassis (refer to
installation instructions 997-452, supplied with the
printer) and then the combined assembly secured to
the back box.
is supplied with the printer already fitted. Refer to
installation instructions 997-224 and 997-452,
supplied with the extension chassis.
are connected.
the end of the roll to the paper entry slot on the
underside of the printer mechanism (N) - the printer
will automatically try to take up the paper.
paper, you may need to feed the paper manually.
Manual feed is achieved by repeatedly pressing
the ' ' pushbutton at the panel controls (while
panel status is normal).
orientated as shown, until it protrudes from both ends
of the roll in approximately equal lengths.
forward to check that the spindle (O) has engaged in
the notch (P). After the paper roll/spindle assembly is
in position, gently turn the roll to take up any slack in
the paper.
997-274-000-6, Issue 6
September 2009