Isolated Rs232 Interface Pcb - Honeywell Notifier ID3000 Series Installation & Commissioning Manual

Make sure you have
a PC back-up of the
current
configuration data
WARNING - Discon-
nect ALL power from
the ID3000
Series panel
Upper Edge
Socket SK12 or SK13 on Base PCB
RS232 PCB - Part Number 124-300
997-274-000-6, Issue 6
September 2009
ID3000 Series Installation & Commissioning Manual

5.11 Isolated RS232 Interface PCB

The ID3000 Series Isolated RS232 Interface PCB
(PN: 124-300) enables connection of the ID3000 Series
Fire Control Panel to an external printer, terminal or third-
party-protocol station. The RS232 Interface PCB is
located adjacent to and at the left-hand side of the Base
PCB. The PCB is secured in position using one metal
spacer and SEM screw and three nylon snap-top spacers,
all provided with the Isolated RS232 Interface PCB kit
(PN: 020-478).
To fit the Isolated RS232 Interface PCB follow the
instructions below. Only one Isolated RS232 Interface
PCB is supported.
Before starting, make sure you have a PC back-up of
the panel's current configuration data.
Ensure you take appropriate anti-static precautions
before undertaking this procedure.
With the front cover moulding(s) removed (see
Section 2.7) and power disconnected, proceed as
follows:
1 Using a suitable-sized coin, release the two quarter-
2 Fit the metal spacer (E) through the Base PCB to the
3 Fit the three supplied nylon snap-top spacers (G)
4 Observing anti-static precautions, remove the RS232
5 Use the M3 x 8mm SEM screw (I) to secure the
6 Make all necessary wiring connections to the Isolated
7 If no other PCBs require fitting, close and secure the
8 To replace the Isolated RS232 Interface PCB, first
Lower Edge
38
turn fasteners (A) located at the left-hand side of the
main chassis front door (B). Open the door to gain
access to the main chassis' PCB enclosure (C)
containing the Base PCB (D).
top left fixing position of either PCB mounting location
(F). Tighten down fully using a 5.5mm Hex socket tool.
through the Base PCB by pushing them firmly into
place until they snap into position.
Interface PCB from its packaging. If, after inspection, no
damage has occurred in transit and with it correctly
orientated, carefully offer the PCB to the three snap-top
spacers described in step 3. Working in a clockwise
direction, carefully push the PCB onto the snap-top
spacers (positions H) until the PCB is secure.
Isolated RS232 PCB to the metal spacer (position J).
RS232 Interface PCB - see details below.
main chassis front door, re-connect mains power and
the batteries and replace the front cover moulding.
reverse the above procedure, steps 4 to 7, and then
fit the replacement PCB using steps 4 to 7.