Cable Terminations - Honeywell Notifier ID3000 Series Installation & Commissioning Manual

ID3000 Series Installation & Commissioning Manual

3.1.1 Cable Terminations

This section provides guidance on where to bring cables
into the back box for ease of termination. Ensure the
following requirements are met:
a. If the power supply unit (PSU) is mounted in the back
b. If the PSU is mounted externally to the panel, the dual-
c. All loop and ancillary cable terminations should be
d. A row of knockouts, 'u', should be left to provide
15
box, the mains supply should be brought into the
control panel such that the cable path to the mains
termination block is kept as short as possible.
supply power cables and appropriate fault condition
wiring should be brought into the panel using the
bottom face's knockouts (as indicated). Refer to
Section 5.3 Dual Transmission Path/Booster
Module for termination details.
brought into the panel at suitable positions to ensure
tails are kept as short as possible.
adequate mains supply input/signal cable segregation.
The drawing shows the recommended points
of entry so that cabling can meet these
requirements.
Panel with internal PSU
i. Base PCB cabling/wiring terminations
using top-face knockouts 'a, b, f and g'.
ii. Base PCB cabling/wiring terminations
using rear knockouts 'd, e, h and i'.
iii. RS232 or RS485 cabling terminations using
rear knockouts 'k and l'.
iv. Loops 3/4, 5/6, 7/8 cabling using top face
knockouts 'm/n, o/p and q/r' respectively.
v. Power supply cable entry using knockouts 's'.
Panel with external PSU
As above except for item v above, which is
replaced with:
vi. DTP/Booster Module cabling using
knockouts 't'. See external PSU and DTP/
Booster Module instructions for details.
997-274-000-6, Issue 6
September 2009