Meaning Of The Leds; Technical Data - Siemens SINAMICS Equipment Manual

5.2.3

Meaning of the LEDs

Table 5-20 Meanings of the LEDs on the Terminal Module TM31
LED Color
READY -
Green
Orange
Red
Green/re
d
Green/
orange
or
Red/
orange
See List Manual for the parameter to activate the recognition of components via LED
1)
5.2.4

Technical data

Table 5-21
6SL3055-0AA00-3AAx
Electronics power supply
Voltage
Current (without DRIVE-CLiQ
and digital outputs)
Power loss
Response time
PE/ground connection
Weight
Degree of protection
Supplementary component descriptions
Manual, 06/2019
Status
Off The electronics power supply is missing or outside the per‐
missible tolerance range.
Continuous The component is ready for operation. Cyclic DRIVE-CLiQ
light communication is taking place.
Continuous DRIVE-CLiQ communication is being established.
light
Continuous This component has at least one fault.
light
Note:
The LED is activated regardless of whether the correspond‐
ing messages have been reconfigured.
Flashing Firmware is being downloaded.
light 0.5 Hz
Flashing Firmware download has been completed. The system waits
light 2 Hz for POWER ON.
Flashing Component recognition via LED is activated
light
Note:
Both options depend on the LED status when component
recognition is activated via p0154 = 1.
Technical data
Description, cause
Unit Value
V 24 (20.4 ... 28.8)
DC
A 0.5
DC
W < 10
The response time of the digital inputs/outputs and the
analog inputs/outputs comprise the following:
● Response time on the component itself
(approx. 1/2 DRIVE-CLiQ cycle).
● Transfer time via the DRIVE-CLiQ connection
(approx. 1 DRIVE-CLiQ cycle).
● Evaluation on the Control Unit (see function diagram).
At the housing with M4/1.8 Nm screw
kg 1
IP20
Terminal Modules
5.2 Terminal Module TM31
Remedy
–
–
–
Remove and acknowl‐
edge the fault.
–
Carry out a POWER
ON.
. –
1)
71