Meaning Of Leds - Siemens SINAMICS Equipment Manual

7.3

Meaning of LEDs

Table 7-5 Meaning of LEDs on the Sensor Module Cabinet SMC30
LED Color
RDY –
READY
Green
Orange
Red
Green/red Flashing
Green/red Flashing
Green/
orange
or
Red/
orange
OUT > 5 V –
Orange
See List Manual for the parameter to activate the recognition of components via LED
1)
Supplementary component descriptions
Manual, 06/2019
Status Description, cause
Off The electronics power supply is missing or outside the per‐
missible tolerance range.
Continu‐ The component is ready for operation. Cyclic DRIVE-CLiQ
ous light communication is taking place.
Continu‐ DRIVE-CLiQ communication is being established.
ous light
Continu‐ This component has at least one fault.
ous light
Note:
LED is controlled irrespective of the corresponding messages
being reconfigured.
Firmware is being downloaded.
light 0.5
Hz
Firmware download has been completed. The system waits
light 2 Hz for POWER ON.
Flashing Component recognition via LED is activated
light
Note:
Both options depend on the LED status when component
recognition is activated.
Off The electronic power supply is missing or outside permissible
tolerance range.
Power supply ≤ 5 V.
Continu‐ The electronics power supply for the encoder system is avail‐
ous light able.
Power supply > 5 V
Notice
Make sure that the connected encoder can be operated with
a 24 V power supply. If an encoder that is designed for a 5 V
supply is operated with a 24 V supply, this can destroy the
encoder electronics.
Sensor Module Cabinet-Mounted SMC30
7.3 Meaning of LEDs
Remedy
–
–
–
Remedy and acknowl‐
edge fault
–
Carry out a POWER
ON
. –
1)
–
–
93