Dhcp Settings - Huawei EG860 Series User Manual

EG860
User Guide
l If the APN in use does not match the operator, Internet services will be unavailable.
l The APN in use cannot be deleted.
l The default APN cannot be edited or deleted.
Step 4 Click Edit APN Profile and configure APN, Dialed Number, User Name, and Password.
Step 5 Click Submit.
----End

7.2.3 DHCP Settings

A Dynamic Host Configuration Protocol (DHCP) server manages all the equipment and assigns
IP addresses to them within a LAN or WLAN.
Context
After changing parameter values of a
l
l
Procedure
Step 1 Choose General Settings > DHCP Settings. The DHCP Settings page is displayed.
Step 2 In LAN Host Settings, configure IP address, Subnet mask, and DHCP server.
Configure related network parameters on the router.
Step 3 In DHCP Settings, configure Start IP address, End IP address, and Lease time.
The related parameters are as follows:
l Configure Start IP address and End IP address in the same network segment with IP
l Set Lease time to values ranging from 1 min to 10080 min.
Click Connected Devices, the Connected Devices page is displayed. The Devices List displays
the active devices connected to the EG860 through the LAN and WLAN.
Step 4 Click Set Up List and configure Reserved Address List.
If the
the same
l Configure MAC Address and IP Address as required.
l Status indicates validity of all the preceding configurations. Done indicates that all the
Step 5 Click Submit.
----End
Issue 02 (2015-04-10)
Log in to the EG860 again using the new IP address because the EG860 needs to be
restarted.
Check port mapping status.
address in LAN Host Settings.
MAC address of equipment is a static
IP address to the equipment. The related parameters are as follows:
configurations are valid. Waiting indicates that the configurations will take effect upon
restart.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
DHCP server, perform the following operations:
IP address, the DHCP
7 Reference
server will always assign
84