Huawei EG860 Series User Manual page 111

EG860
User Guide
Procedure
Step 1 Choose System > Diagnosis. The Diagnosis page is displayed.
Step 2 Configure Method as required.
l If Method is set to Ping, you can ping Destination IP address or domain to help diagnose
l If Method is set to Traceroute, you can use the Traceroute function to test Destination IP
l If Method is set to System check, check the equipment status and output the result.
l If Method is set to Main/Neighbor Cell, current main/neighbor cell information will be
l If Method is set to Chip temperature, the ambient temperature inside the equipment will
l If Method is set to Tcpdump, the system automatically selects the size of the packets
l If Method is set to Tmsi, click Query to query the current
l If Method is set to Up/Down Throughput, current throughput information will be displayed
l If Method is set to Work Frequency, the locked working frequency is displayed. "0"
l If Method is set to Packet Stats, and Packet Stats is set to Enable, the number of received/
l If Method is set to WAN ICMP, and WAN ICMP is set to Enable, the WAN ICMP function
----End
Issue 02 (2015-04-10)
network faults.
The related parameters are as follows:
– Destination IP address or domain: indicates the destination
– Packet size: indicates the number of transmitted bytes and ranges from 1 bytes to 9,000
bytes.
– Timeout: indicates the timeout period for each response and ranges from 1s to 10s.
– Do not Fragment: Set this parameter to Enable or not as required.
address or domain to help diagnose network faults.
The related parameters are as follows:
– Destination IP address or domain: indicates the destination
– Maximum hops: indicates the maximum number of hops tested by traceroute and ranges
from 1 to 100.
– Timeout: indicates the timeout period for each response and ranges from 2s to 10s.
displayed in the result.
be displayed in the result.
captured at the port based on the number of ports where packet capture is performed. The
fewer the selected ports, the longer the period of packet capture.
NOTE
Packet capture lasts less than 10 minutes. After packet capturing is completed, click Export to save
the packet capturing file.
card.
in the result.
indicates that no frequency is locked.
transmitted packets is collected.
is switched on.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
7 Reference
IP address or domain name.
IP address or domain name.
TMSI parameters of the data
102