Wlan Settings; Wlan Multi-Ssid - Huawei EG860 Series User Manual

EG860
User Guide

7.2.4 WLAN Settings

Wi-Fi equipment can connect to the Internet within the range of a WLAN.
Context
When
will be disconnected for about 30s.
Procedure
Step 1 Choose General Settings > WLAN Settings. The WLAN Settings page is displayed.
Step 2 Configure the parameters in General Settings.
The parameters in General Settings are basic control parameters for
configurations are valid only when the
l Set WLAN Status to Enable and configure the
l Mode can be set to 802.11b/g, 802.11b, 802.11g, 802.11n, or 802.11b/g/n.
l Channel value range: 1-13. If this parameter is set to Auto, the system automatically selects
l 802.11n bandwidth can be set to 20 MHz or 20/40 MHz.
l Rate is set to Auto by default.
l Transmit power can be set to 5%, 30%, 60%, 80%, 90%, or 100%. 90% is recommended.
l If QoS is set to Enable, the QoS function is enabled for the WLAN.
Step 3 Configure the parameters in Interface Profile.
The related parameters are as follows:
l Auto SSID name is set to Enable, SSID is not manually set, and SSID is recommended to
l SSID indicates a
l Set Maximum number of connected devices to a value from 1-32.
l If Hide SSID broadcast is set to Enable, the
l If AP isolation is set to Enable,
l Security can be set to NONE, WPA-PSK, WPA2-PSK, or WPA-PSK+WPA2-PSK.
l WPA-PSK is the password to access the WLAN, and consists of 8 to 63 ASCII characters
l WPA encryption can be set to AES, TKIP, or TKIP+AES. AES is recommended.
Step 4 Click Submit.
----End

7.2.5 WLAN Multi-SSID

WLAN Multi-SSID allows four channels for Wi-Fi LAN access at different speeds based on
customer and application requirements.
Issue 02 (2015-04-10)
WLAN parameters are modified, the
Enable by default.
a channel with the lowest interference.
set it to WLAN-SN.
WLAN
WPA2-PSK is recommended.
or 8 to 64 hexadecimal characters. The value is WLAN1-TDLTE by default, and can be
changed as required.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Wi-Fi equipment needs to restart and the
WLAN is enabled. The related parameters are as follows:
Wi-Fi
port, that is, the name of the user that accesses the WLAN.
WLAN
Wi-Fi equipment cannot interact.
WLAN ports. The
function. WLAN Status is set to
port will not be scanned.
7 Reference
WLAN
85