Huawei EG860 Series User Manual page 67

EG860
User Guide
4.
Step 4 (This step is for the installation of external antenna. Please skip this step if built-in antenna is
used.) Install an antenna. Connect the antenna to EG860 using a ground device (DC) for the
central conductor.
conductor is mainly used for detecting external antenna and some surge protection.
EG860 supports single antenna and double antennas.
l In single antenna mode, the antenna connects with RF1 of EG860.
l In double antennas mode, the antennas respectively connects with RF1 and RF2 of EG860.
Figure 4-42 DC for the central conductor
1.
Issue 02 (2015-04-10)
Figure 4-41 Connecting the power cable to the EG860
Optional: In outdoor scenarios, waterproof the connecting joints as shown in 2.4.
Figure 4-42
The two antennas must be in the same horizontal position, with a minimal interval of 1.5
meters.
Loosen the antenna connector, as shown in
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
shows the DC for the central conductor. The DC for the central
Figure 4-43.
4 Installation
58