Plc Settings - Pro-face GP77R Series Connection Manual

PLC SETTINGS

HIDAC H Series
Source IP Address
*1 Contact your network administrator about what setting values to use.
*2 PLC unit's default Port number is 9600. Be sure to use the same number as
• Be sure not to set a duplicate Node Address in the same Network
Web Controller
Source IP Address
*1 Contact your network administrator about what setting values to use.
*2 The Port Number setting range is from 1024 to 65535.
*3 When using the GP2000 Series unit's internal ethernet port, be sure the [Logic
GP-PRO/PBIII for Windows Device/PLC Connection Manual
GP Settings
GP IP Address
Source Node
GP Port No.
Address
Target PLC IP
Destination IP
Address
Address
Destination IP Port
3004 to 3007
No.
Protocol type UDP/TCP
the GP setting.
When using the GP2000 Series unit's internal ethernet port, be sure the [Logic
Port No.] value is different fron the 2-Way Driver port number values. Check
the 2-Way driver's port number setting via the following menu:
From the GP OFFLINE mode's Main menu [INITIALIZE] -> [SETUP OPERA-
TION SURROUNDINGS] -> [EXTENDED SETTINGS] -> [SETUP ETHERNET
INFORMATION].
The default value is 8000. The 2-Way driver uses this port and the following
nine ports for a total of 10 (8000 ~ 8009).
Address group.
GP Settings
GP IP Address
Source Node
GP Port No.
Address
Target PLC IP
Destination IP
Address
Address
Destination IP Port
3004 to 3007
No.
Protocol type TCP/IP, UDP
Port Number] value is different fron the 2-Way Driver port number values.
Check the 2-Way driver's port number setting via the following menu:
From the GP OFFLINE mode's Main menu [INITIALIZE] -> [SETUP OPERA-
TION SURROUNDINGS] -> [EXTENDED SETTINGS] -> [SETUP ETHERNET
INFORMATION].
The default value is 8000. The 2-Way driver uses this port and the following
nine ports for a total of 10 (8000 ~ 8009).
Hitachi Industrial Equipment System - Ethernet
PLC Settings
*1
*2
IP Address
*1
Logic Port No.
Service Assortment
Task Code Port Time
Out Value
PLC Settings
*1
1* *2 *3
Auto IP Address
*1
Task Code Port
1* 2*
Port No. (1 to 4)
Task Code Port
Protocol Type
Mode Switch
GP Node Address
UDP/IP, TCP/IP
20 sec. or longer
*1
PLC IP Address
*1 *2
3004 to 3007
TCP/IP, UDP
0
21