Pro-face GP77R Series Connection Manual page 19

Hitachi Industrial Equipment System - Ethernet
• Source IP Address (0 to 255)
• Source IP Port No. (1024 to 65535)
• Destination IP Address (0 to 255)
• Destination IP Port No. (1024 to 65535)
• Protocol Type
•ADVANCED COMMUNICATION SETUP
• Send Wait Time (0 to 255)
• Time Out (0 to 65535)
• IP Router Address
18
Enter the IP address for the GP at your station. To do this, separate the 32 bits
of the IP address into four segments of eight bits each, separate those segments
with a dot and then enter them as decimal numbers.
Enter the GP's Port No. from 1024 to 65535.
This setting cannot be used. Set the Destination IP Address from [Network
Information Setting] in [Mode Setting] tab.
Enter the PLC's IP Port No. from 1024 to 65535. Enter the same value as the
PLC's Logic Port No.. When connecting a single GP unit to multiple PLC units,
set all PLC units' Port No. to the same value.
Select UDP/IP or TCP/IP Communication. When the power is turned ON/
OFF asynchronously , we recommend UDP/IP Communication.
Wait time can be added when a command is transmitted from the GP. Use the
wait time if the traffic on the communications line is heavy. If no wait time is
required, enter "0."
Enter the desired timeout value. If no response is received from the other station
within the specified time, a timeout occurs. If "0" is specified, the default time is
5 seconds with UDP/IP communication.
Enter the IP address of the router (only one). If no router is used, enter "0" in all
fields.
GP-PRO/PBIII for Windows Device/PLC Connection Manual